Sony MDS-JE500 To select, Until, If you entered the wrong character, To erase a character

3Press DISPLAY/CHAR to select the character type as follows:

To select	Press DISPLAY/CHAR repeatedly
	until
Uppercase letters	“A” appears in the display
Lowercase letters	“a” appears in the display
Numbers	“0” appears in the display

4Turn AMS to select the character.

The selected character flashes.

Letters, numbers, and symbols appear in sequential order as you turn AMS.

You can use the following symbols in titles:

!” # $ % & ’ ( ) * + , – . / : ; < = > ? @ _ `

You can press DISPLAY/CHAR to change the character type at any time during Step 4 (see Step 3).

5Press AMS to enter the selected character. The cursor shifts rightward and waits for the input of the next character.

Editing Recorded MDs

6Repeat Steps 3 to 5 until you have entered the entire title.

If you entered the wrong character

Press 0 or ) until the character to be corrected starts flashing, and repeat Steps 3 to 5 to enter the correct character.

To erase a character

Press 0 or ) until the character to be erased starts flashing, then press EDIT/NO.

To enter a space

Press AMS or ) while the cursor is flashing.

7Press YES.

This completes the labeling procedure and the title appears on the left side of the display.

To cancel labeling

Press p.

Note

You cannot label a track or an MD while you are recording over an existing track.

(Continued)

27