9If necessary, locate the point on the MD to start recording from.

If you want to record on a new MD or start recording from the end of the recorded portion, go to step 10.

To record over from the beginning of an existing MD track

Turn AMS (or press ./> repeatedly) until the number of the track to be recorded over appears.

To record over from the middle of an MD track

Turn AMS (or press ./> repeatedly) until the number of the track to be recorded over appears, then press N to start playback. Press X at the point you want to start recording from.

10Press z.

The deck changes to recording pause.

11If you have set INPUT to ANALOG in step 4 above, adjust the recording level.

For details, see “Adjusting the Recording Level” on page 16.

12Press N or X.

Recording starts.

13Start playing the program source.Operations you may want to do during recording

To

Press

Stop recording

x

 

 

Pause recording

X

 

 

Resume recording after pausing

N or X

 

 

Eject the MD

EJECT Z after stopping

 

recording

 

 

When you pause recording

The track number increases by one. For example, if you paused recording while recording track 4, the track number will be 5 when you resume recording.

To prevent accidental erasure of the recorded material

To make it impossible to record on an MD, slide the record-protect tab in the direction of the arrow (see illustration below) to open the slot. To enable recording, close the slot.

Bottom side of the MD

Record-protect tab

 

Slide in the directionof arrowzTo play the tracks you just recorded

Press N immediately after stopping recording.

The deck starts to play from the first track of the material just recorded.

zTo play from the first track of the MD after recording 1 Press x again after stopping recording.

2 Press N.

The deck starts to play from the first track of the MD.

Note

You can’t record over existing material when Shuffle Play (page

24)or Program Play (page 25) has been selected. “Impossible” appears in the display at this time.

MDs on Recording

15