25
GB
Additional Information
MHC-EC619iP.4-467-785-22(1)
The sound is distorted.
Make sure the iPod/iPhone is
connected securely.
Turn down the volume.
Set the “EQ” setting of the iPod/
iPhone to “O” or “Flat.”
The iPod/iPhone does not function.
Shut down any other “iOS”
applications running on the iPod/
iPhone. For details, refer to the
operation manual supplied with the
iPod/iPhone.
Make sure the iPod/iPhone is
connected securely.
Because the operation of the system
and the iPod/iPhone are dierent,
you may not operate the iPod/
iPhone using buttons on the remote
control or unit. In this case, perform
operations on the iPod/iPhone.
The connected iPod/iPhone cannot be
charged.
Make sure the iPod/iPhone is
connected securely.
Make sure the system is turned on.

USB device

The connected USB device cannot be
charged.
Make sure the USB device is
connected securely.
Are you using a supported USB device?
If you connect an unsupported USB
device, the following problems may
occur. Check the information on
websites for compatible USB devices
using the URLs listed under “USB
devices” in “Compatible devices with
this system” (page 23).
The USB device is not recognized.
File or folder names are not
displayed on this system.
Playback is not possible.
The sound skips.
There is noise.
A distorted sound is output.
There is no sound.
The USB device is not connected
correctly. Turn o the system, then
reconnect the USB device.
There is noise, skipping, or distorted
sound.
Turn o the system, then reconnect
the USB device.
The music data itself contains noise,
or the sound is distorted. Noise may
have been entered during music
creation process using this system or
the computer. Create the music data
again.
The bit rate used when encoding
the les was low. Send les encoded
with higher bit rates to the USB
device.
“SEARCH” is displayed for an extended
time, or it takes a long time before
playback starts.
The reading process can take a long
time in the following cases.
There are many folders or les on
the USB device.
The le structure is extremely
complex.
The memory capacity is excessive.
The internal memory is
fragmented.
Erroneous display
Characters that cannot be displayed
appear as “_“.
The USB device is not recognized.
Turn o the system and reconnect
the USB device, then turn on the
system.
Check the information on websites
for compatible USB devices using
the URLs listed under “USB devices”
in “Compatible devices with this
system” (page 23).