Inserting the
Batteries
Install two R6 (size AA) batteries in the supplied remote for remote control.
1 Slide the lid to remove it.
2 Insert two R6 (size AA) batteries. Match the + and – to the diagram in the battery compartment.
3 Close the lid.
Battery life
You can expect the remote to operate for about six months (using Sony
To avoid battery leakage
If you are not going to use the remote for a long time, remove the batteries to avoid damage caused by corrosion from battery leakage.
Setting the Clock
The
Use the buttons on the unit to do this operation.
Note
Once you set the clock, the demo mode, that activates when the power is turned off, is cancelled automatically.
SYSTEM |
|
POWER m ON | DISPLAY |
1 | 4,6 | |
3,5 | ||
2 |
1 Press TIMER.
The stereo enters the clock/timer mode.
2 Press CLOCK SET.
The hour indication begins flashing.
flashing
3 Set the current hour by turning the JOG dial until the correct hour appears.
flashing
4 Press ENTER/NEXT.
The minutes indication begins flashing.
flashing
5 Set the current minute by turning the JOG dial until the correct minute appears.
flashing
6 Press ENTER/NEXT.
The clock starts running and the upper dot flashes. Use the time signal to set the clock accurately.
The upper dot flashes for the first half of a minute (0 to 29 seconds), and the lower dot flashes for the last half of a minute (30 to 59 seconds).
flashing
To check the time while power is on
Press DISPLAY a few times.
The current time is displayed for 8 seconds.
To correct the clock setting
Repeat steps 1 through 6.
6
Chapter 1: Setting Up