APPENDIX 6. –FAQ
1. How to disable the DHCP function and use a static IP instead?
A：Turn up the “DIP SWITCH” from “3” to “4” and change the relative network settings, the IP Address, NetMask and Gateway on the image web page.
2. Can the SD card be removed during recording?
A：No, it cannot be removed until the recording comes to a single point. The POWER LED flashing light signals the SD card is operating. The green light indicates the unit is activating. The red light warns the SD card cannot be removed. If the SD card is withdrawn in this mode, the card will break.
3. I’ve set the function of “Motion Detection” but it doesn’t seem to work.
A：Check if “Motion range” and “Sensitivity” have been set before activating the function.
4.My AVI files recorded in the SD card cannot be displayed. What can I do to display the files? A：Please visit
5.How to turn on/off the OSD (on screen display) on/off on the LANCAM?
A：Visit the homepage - tailpage.htm of the device, and select "ON" or "OFF" in the OSD column. Example: suppose the IP address of the device is 192.168.1.168
Type in http://192.168.1.168/tailpage.htm ( a registration is needed) and select "ON" or "OFF" in the OSD column.
WARNING: Please write down the IP address of the device before you turn off the OSD.
RMN0100031_v1.3
102
