83
When bringing the camera from a cold place to a warm place, seal the camera in a plastic bag and allow it to adapt to conditions at the new location over a period of time (about an hour).
How to prevent moisture condensation
• The camera is taken from an air- conditioned room or car interior to the hot outdoors, etc.
• The camera is brought from a cold To protect data recorded on floppy location such as a ski slope into a
disks, note the following:warmly heated room.
• Avoid storing floppy disks near magnets or magnetic fields such as those of speakers and televisions. Otherwise, permanent erasure of disk data may result.
• Avoid storing floppy disks in areas subject to direct sunlight or sources of high temperature, such as a heating device. Floppy disk warping or damage may result, rendering the disk useless.
• Avoid contact with the disk’ surface by opening the disk shutter plate. If the disk’s surface becomes blemished, data may be rendered unreadable.
Wipe the screen surface with a cleaning cloth (optional) or an LCD cleaning kit (optional) to remove fingerprints, dust, etc.
Additional information
Precautions
On cleaning Cleaning the LCD screen
•Avoid getting liquids on the floppy disk.

•Be sure to use a floppy disk case to ensure protection of important data.

•Even when you use a 3.5-inch 2HD floppy disk, image data may not be recorded and/or displayed depending on the using environment. In this case, use a disk of other brand.

 

On operating temperature
Cleaning the camera surface

Your camera is designed for use

Clean the camera surface with a soft

 

between the temperatures°Cofto0

cloth slightly moistened with water,

 

40°C (32°F to 104°F). Recording in
then wipe the surface dry. Do not use

 

extremely cold or hot places that
any type of solvent such as thinner,

 

exceed this range is not recommended.
alcohol or benzene as this may damage
the finish or the casing.

 

On moisture condensation
After using your camera at the

 

seashore or other dusty locations

If the camera is brought directly from a

Clean your camera carefully.

cold to a warm location, or is placed in

Otherwise, the salty air may corrodea very damp room, moisture may the metal fittings or dust may entercondensethe inside or outside the camera.

inside of your camera, causing a

Should this occur, the camera will not

malfunction.operate properly.

 

 

Moisture condensation occurs
On floppy disks

 

 

easily when:

 

 

 

information Additional