23
MZ-NF810/NF810CK
Power Supply Adjustment Auto Item Feed
Note: This mode is available to perform the temperature correction and
power supply adjustment without entering the manual mode.
•Setting method of power supply adjustment auto item feed mode.
1. Set the test mode (see page 13)
2. Press the key or press the [VOL --] key to activate the
overall adjustment mode.
3. Press the [END SEARCH] key or [P MODE] key on the re-
mote commander to set the temperature correction mode.
4. To change the initial value (hexadecimal) adjust with the [VOL
+] or [VOL --] key.
Press the X key to write the adjusted value, and the item num-
ber increases automatically.
When not writing the adjusted value, press the key to
move to the next item.
015 SetTmp **
Remote commander LCD display
key
key
key
key
key
END SEARCH key or P MODE key
on the remote commander.
000Assy **
015 SetTmp 19
741 VC1 L **
742 VC1 H **
743 VC2 Lo **
744 VC2 Hi **
745 REG1 **
752 VREC M **
753 VREC H **
755 ChgV L **
756 ChgV H **
757 CIL **
758 CIH **
000 ADJ OK
747 REG3L1 **
748 REG3L2 **
749 REG3 H **
751 VREC L **
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
key
>
.
.
.
.
key
.
key
.
key
.
key
>
key
.
key
.
key
.
key
.
key
.
key
.
key
.
5. Connect digital voltmeter to the measuring points on the MAIN
board, and adjust the voltage with the [VOL +] or [VOL --]
key. (see page 18 to 21)
Press the X key to write the adjusted value, and the item num-
ber increases automatically.
6. When not writing the adjusted value, press the key to
move to the next item. The key is available to back to the
last item.
7. The following message is displayed after all power supply
adjustments finish.
8. Press the xCANCEL/CHG key to return the test mode (dis-
play check mode).
•Configuration of power supply adjustment auto item feed
.
T
000 Assy **
**
:Adjusted value
Remote commander LCD display
>
t
741 VC1 L **
Remote commander LCD display
.
T
>
t
000 ADJ OK
Remote commander LCD display