Sony MZ-R37SP Messages, Error message, Meaning/Remedy

Messages

If the following error messages flash in the display window, check the chart below.

Error message	Meaning/Remedy
BLANK	• An MD with no recording on it is inserted.
	b Insert a recorded MD.
ERROR	• The disc is damaged or does not contain proper recording or
	editing data.
	b Reinsert the disc. If this fails, rerecord.
FULL	• There is no more space to record on the disc (less than 12 seconds
	available).
	b Replace the disc.
	• You tried to enter more than 200 letters to label a single track or
	disc.
	• You tried to enter a total of more than 1700 letters for track or disc
	names during playback or stop.
	• You tried to enter a total of more than 500 letters for track or disc
	names during a single recording.
	b Enter the characters within the limit.
SAVING	• The recorder is recording information (sounds) from the memory to
	the disk.
	b Wait until this process is completed. Do not expose the recorder
	to any physical shock, nor disrupt power supply.
EDIT	• The recorder is recording information (track start and end position)
	from the memory to the disk.
	b Wait until this process is completed. Do not expose the recorder
	to physical shock, nor disrupt power supply.
BUSY	• You tried to operate the recorder while it was accessing the
	recorded data.
	b Wait until the message goes out (in rare cases, it may take 2–3
	minutes).
HiDCin	• Voltage of the power supply is too high.
	b Use the AC-E45HG (not supplied).
HOLD	• The recorder is locked.
	b Slide HOLD against the arrow to unlock the recorder (page 17).
LoBATT	• Batteries are weak.
	b Charge the rechargeable batteries or replace the dry batteries
	(pages 23, 24).
MEMORY	• You tried to record when there is no indication in the display, with
	the recorder placed where it receives continuous vibration.
	b Put the recorder on a stable place, and start recording again.

30