3Record an MD.

REC

1 Press and slide REC upward.

“REC” lights up and recording starts.

p•CHARGE

2 Play the CD or tape you want to record.

CD player, cassette recorder, etc. (source)

To stop recording, press p.

“SAVING” or “EDIT” flashes while data of the recording (the track’s start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display.

To

Press

Pause

P.1)

 

Press Pagain to resume recording.

Record from the end of the previous recording

END SEARCH and slide REC upward.

Record partway through the

(, +or =to find the start point

previous recording

of recording and press pto stop. Then

 

slide REC upward.

 

 

Remove the MD

pand slide OPEN to open the lid.2)

1)A track mark is added at the point where you press P; thus the remainder of the track will be counted as a new track.

2)Once you open the lid, the point to start recording will change to the beginning of the first track. Check the point to start recording on the display.

If the recording does not start

•Make sure the recorder is not locked (page 17).

•Make sure the MD is not record-protected (page 26).

•Premastered MDs cannot be recorded over.

Note

If the power supply is disrupted (i.e. the battery is removed or becomes exhausted or the AC power adaptor is disconnected) when the recorder is operating, the lid will not open until the power is restored.

z

•The level of the recorded sound is adjusted automatically.

•You can monitor the sound during recording. Connect the supplied headphones to PHONES/REMOTE and adjust the volume by pressing VOL +/–. This does not affect the recording level.

7