3Record an MD.
p
REC
CD player, cassette recorder, etc. (source)
1Press and slide REC to the right .
“REC” lights up and recording starts.
2Play the CD or tape you want to record.
To stop recording, press p.
“Data Save” or “Toc Edit” flashes while data of the recording (the track’s start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display.
To | Press |
Pause | P1) |
| Press Pagain to resume recording. |
Record from the end of the previous recording
END SEARCH and slide REC.
Record partway through the | (, +or =to find the start point |
previous recording. | of recording and press pto stop. Then |
| slide REC. |
|
|
Remove the MD. | pand open the lid.2) |
1)A track mark is added at the point where you press P; thus the remainder of the track will be counted as a new track.
2)Once you open the lid, the point to start recording will change to the beginning of the first track. Check the point to start recording on the display.
If the recording does not start
•Make sure the recorder is not locked (page 20).
•Make sure the MD is not
•Premastered MDs cannot be recorded over.
Note
If the power supply is disrupted (i.e. the battery is removed or becomes exhausted or the AC power adaptor is disconnected) when the recorder is operating, the lid will not open until the power is restored.
z
•The level of the recorded sound is adjusted automatically.
•You can monitor the sound during recording. Connect the supplied headphones with remote control to 2/ REMOTE and adjust the volume by pressing VOLUME +/– (VOL +/– on the remote control). This does not affect the recording level.
7