
Troubleshooting
If you run into any problem using this unit, use the following table to troubleshoot the problem. If the problem persists, disconnect the power source and contact your Sony dealer or local authorized Sony service facility.
Symptom | Cause and/or Corrective Actions |
Print paper cannnot be | •The printer is not attached correctly. |
drawn in the paper feeder. | t Attach it correctly. |
| •The battery power is low. |
| t Use the battery pack charged fully. |
| •The print cartridge is not inserted. |
| t Insert the print cartridge. |
| •You have inserted print paper into the |
| paper feeder right after you turned the |
| power source on or right after you |
| opened the printer cover. |
| t Remove the print paper once. |
| Make sure that the PAPER lamp is |
| flashing slowly, and then insert print |
| paper into the paper feeder. |
| •The POWER switch on your camcorder is |
| not set to MEMORY. |
| t Set it to MEMORY. |
| •The print paper is not inserted properly. |
| t Press the print paper into the paper |
| feeder for about two seconds after the |
| beep sounds. |
| •Printing images continuously makes the |
| inside of the printer heat up. When this |
| happens, you may not be able to insert |
| print paper. |
| t Leave this unit until it cools down, |
| then insert print paper into the paper |
| feeder again. |
| •SLIDE SHOW is executed on your |
| camcorder. |
| t Cancel SLIDE SHOW or inset the |
| print paper again after SLIDE SHOW |
| has completed. |
Images do not become still | •Print paper or the print cartridge is not |
images even you press | inserted. |
PRINT. | t Insert the print paper or the print |
| cartridge. |