, The remote’s manufacturer code returned to

The disc tray does not open and

the default setting when you replaced the

“TRAYLOCKED” appears in the front panel

batteries. Reset the code (page 24).

display.

, The remote is not pointed at the remote

, Contact your Sony dealer or local

sensor on the recorder.

 

authorized Sony service facility.

OthersThe recorder does not detect a USB device connected to the recorder.

,Make sure that the USB device is securely connected to the recorder (page 126).

,Check if the USB device or a cable is damaged.

,Check if the USB device is on.

Display language on the screen switches automatically.

,When “HDMI Control” is set to “On” in the “HDMI Output” setup (page 148), the display language on the screen automatically switches, according to the language setting of the connected TV, if you change the language settings on your TV, etc.

The recorder does not operate properly.

,Press down [/1 on the recorder for more than five seconds until the recorder turns off. Then, press [/1 again to turn on the recorder.

,When static electricity, etc., causes the recorder to operate abnormally, turn off the recorder and wait until the clock appears in the front panel display. Then, unplug the recorder and after leaving it off for a while, plug it in again.

The disc tray does not open after you press

Z(open/close).

,It may take a few seconds for the disc tray to open after you have recorded or edited a DVD. This is because the recorder is adding disc data to the disc.

Any buttons do not function and “LOCKED” appears in the front panel display.

,The recorder is locked. Cancel the Child Lock (page 81, 108).

“REPAIR” appears in the front panel display.

,The recorder’s repair function is activated to repair the hard disk drive or disc when the recorder is turned on after a power failure has occurred during recorder operation, such as while recording, or when some errors have occurred. Leave the recorder on until “REPAIR” disappears from the front panel display.

“E01” appears in the front panel display.

,There is a problem in the HDD. Contact your nearest Sony dealer. Note that contents on the HDD may be erased when servicing this unit.

“E02” appears in the front panel display.

,A hard disk error has occurred and you cannot make a new recording to the HDD. Press and hold [/1 on the recorder for more than five seconds to turn the recorder off, then turn it on again. If “E02” still appears, format the HDD following the instructions of “Format HDD.” (page 128). Note that all of the recorded contents on the HDD will be erased. If this does not fix the problem, contact your nearest Sony dealer.

“HDCP_ERR” appears in the front panel display.

,The recorder is connected to an input device that is not HDCP compliant. Connect the equipment that is HDCP compliant (page 19).

Disregard this error message if the output picture is displayed correctly.

The Parental Lock does not work.

,Check the “D.TV Age Limit” setting in the “Parental Lock” setup (page 146).

Information Additional

,continued 157