Setting this stand
Preventing the TV from toppling over
As a protective measure, secure the TV. Perform following steps as a protective measure if you have a Sony LCD TV.
4 While supporting the TV, tighten the support belt to secure in place.
Installing the shelf board
1 Insert the attaching shelf support pins (supplied) into the holes in the stand.
2 Fit the shelf board onto the shelf support pins horizontally. This requires people.
Started Getting
(large)
1
2 Fasten the support belt (supplied) to the stand with the small screw (supplied).
Tighten the screw into the rear hole, as in the illustration.
3 Fit the support belt to the TV, then firmly fasten with the large screw (supplied) using a screw driver or coin, etc.
Installing this stand
Install the stand after connecting all the components to the stand.
Install the stand, allowing for at least 10 cm space between the wall and the rear of the stand, and 30 cm between the wall and the left side of the stand. This is to allow for heat dissipation and to prevent the TV from falling.
At |
|
least | At least |
30 cm | 10 cm |
Note
•Be careful not to pinch your fingers when setting up the stand.
9GB