Lists the Using

Programming the Remote

You can customize the remote to match the components connected to your receiver. You can even program the remote to control non-Sony components and also Sony components that the remote is normally unable to control. The procedure below uses as an example a case in which a Kenwood LD player is connected to the VIDEO 2 jacks on the receiver.

Before you begin note that:

—You cannot change the settings of TUNER and

PHONO.

—The remote can control only components that accept infrared wireless control signals.

Be sure to turn on the receiver and point the remote towards the receiver when performing the following procedure.

1Press SET UP.

The set up list appears.

IR SET

AUTO POWER

BACK LIGHT

2Move the easy scroll key to select “IR SET,” then press the key to enter the selection.

The IR SET list appears.

<IR SET>

[ VIDEO1 ] [ VIDEO2 ]

3Move the easy scroll key to select the component (“VIDEO 2,” for example), then press the key to enter the selection.

The CATEGORY list appears.

CATEGORY?

VCR

T V

4Move the easy scroll key to select the category (i.e., the component that is actually connected to the corresponding jacks; in this case, “LD”), then press the key to enter the selection.

The MAKER list appears.

MAKER?

Sony

DENON

5Move the easy scroll key to select the maker of the component (“Kenwood,” for example), then press the key to enter the selection.

When programming the remote to control Sony component

Select “Sony.”

Programming is now completed.

To cancel programming

Move the easy scroll key to select “EXIT” from the IR SET list, or “CANCEL” from the CATEGORY list or MAKER list, then press the key to enter the selection.

zYou can freely assign any component to USER 1 and 2 items in the IR SET list

1Do Steps 1 and 2 in “Programming the Remote”.

2Move the easy scroll key to select “USER 1” or “USER 2,” then press the key to enter the selection.

3Continue from Step 3 in “Programming the Remote” to select the category and maker of the component.

16