Sony RM-VL1000T 73

SymptomRemedy

The component set to be operated by the timer of the Commander does not function as expected.

The timer programme is executed in the next week or on the next day though that programme has been already executed.

“BATT” is displayed for a second when you try to use the Commander.

The clock is displayed as “--:--”.

“LOCK” is displayed on the LCD and the display for operation does not appear when you press a button.

•The component could not receive the signal from the Commander successfully. When using the timer, check the following.

-Check that the timer macro programme functions correctly by pressing the TEST key, after programming the timer (page 58).

-Check the location of the Commander.

•The status of each component is not suitable for operation. (For example, you programme the power-on setting, assuming that power of the component is off when the timer turns on. However, if power of the component is on when the component receives the timer signal from the Commander, the component will turn off.)

•The timer programme contents you have set on this Commander repeat weekly or daily. If you want to execute the timer programme once, set the timer standby mode to off after the execution of the timer programme (page 58).

•The batteries begin to be exhausted. Replace the batteries as early as possible (page 7).

•The batteries might have been replaced. Replace the batteries with new ones (page 7). After replacing the batteries, the set contents remain. So, to use the Commander with the previous set contents, you should only set the clock (page 8).

•The Hold function is on. Unlock the Hold function (page 62).

73

Contents

Page Page Features Table of Contents Getting Started Basic Operations Advanced Features Using Other Functions Additional Information Appendices Location and Function of Controls Installing the Batteries When to replace the batteries Setting the Clock Setting the clock for the first time after installing batteries MON 9:00 PM STD TIME 9:30 PM Adjusting the clock after setting the clock 1,5 WED 10:00 AM STD TIMEDS TIME 10:00 AM Setting the Code for Preset Audio and Visual Components Setting a component code VCR2 VCR3 Page Checking if the code number works Page Page To clear the contents programmed for a specific component label CH MACRO VOLUME POWER ON COPY ALL COMPLETE Operating Your Components with the Remote Commander ANT SW SEARCH t SEARCH T PLAYx2 Q.TIMER Using Non-Preset Remote Control Operations ANT SW SEARCH Page Page Page Notes on learning the signals of an air- conditioner For accurate learning Changing or erasing the function of a taught label or button Controlling the Volume of Visual Components Connected to an Audio System VISUAL AUDIO Page Page Executing a Series of Commands Programming a series of commands for the System Macro labels SONY OFF SYSTEM2 SYSTEM3 SYSTEM4 Page Page Notes on System Control Operations Page Programming a series of commands for the component labels Page INTERVAL TIME 400ms 650ms 900ms 1sec 2sec Adding an Extra Function to the Component Labels OFF Assigning Other Components to the Component Labels Copying the settings of a component label to another label Page Selecting a Programme with a Single Label Page Page Setting the Timer Setting the new timer ON/OFF TEST SETUP 12:00 AM MACRO EVERYDAY MON-SAT MON-FRI SUN SAT TUE 7:30 AM Page Page NG MacroCLR Page Page Page Page Locking the Controls LOCK Adjusting the Automatic-OffTime of the Backlight of the Display Window Setting the Key- Touch Beep Contrast of the Display Window Changing the Names of the Labels on the Display Page Page Erasing All the Settings YES NO Precautions Maintenance Specifications Troubleshooting Page Page Table of Preset Functions SAT1, SAT2 (Satellite) DVD VCR1, VCR2, VCR3 AMP Page DAT TAPE A, TAPE B Index