7 Press l AMS L (or ENTER on the remote).
The player status returns to Step 4. Repeat Steps 4 through 7 for more adjustments.
8 Press MENU on the player after you finish adjusting.
The display returns to the normal display.
Selecting the distance unit
In Step 4 above, select “DIST UNIT”.
Turn l AMS L (or press ./> on the remote) to select
Setting speaker distances back to the default
Set all speaker distances to 3 meters (10 feet).
Additional Information
Precautions
On safety
•Caution – The use of optical instruments with this product will increase eye hazard.
•Should any solid object or liquid fall into the cabinet, unplug the player and have it checked by qualified personnel before operating it any further.
•AC power cord must be changed only at the qualified service shop.
•The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.
On power sources
•Before operating the player, check that the operating voltage of the player is identical with your local power supply. The operating voltage is indicated on the nameplate at the rear of the player.
•The player is not disconnected from the mains as long as it is attached to the mains, even if the player itself has been turned off.
•If you are not going to use the player for a long time, be sure to disconnect the player from the mains. To disconnect the mains lead, grasp the plug itself; never pull the cord.
On placement
•Place the player in a location with adequate ventilation to prevent heat
•Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom.
•Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.
On operation
•If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the player. Should this occur, the player may not operate properly. In this case, remove the disc and leave the player turned on for about an hour until the moisture evaporates.
•During power on, some noise may be heard while the disc is being loaded into the Super Audio CD player. This is not a malfunction.
Information Additional
continued