Sony Ericsson T18LX manual Troubleshooting, Settings, then Control Panel. Double-click

￿￿Connect one end of your serial cable to your Erics- son mobile phone and the other end to your com- puter’s serial port.

￿￿From the Start menu on your Windows desktop, click on Settings, then Control Panel. Double-click the Modems icon.

￿￿Click Add.

￿￿At the Install New Modem screen, select Other. Click Next.

￿￿At the next Install New Modem screen, select Don’t run Hardware Installation Wizard then click Next.

￿￿At the next Install New Modem screen, select Don’t detect my modem, I will select it from a list then click Next.

￿￿At the next Install New Modem screen, click on Have Disk.

￿￿At the Install from Disk screen, select D:\ at Copy from Manufacturer’s Disk (if your CD-ROM drive is not drive D, type the correct CD-ROM drive des- ignation).

￿￿￿At the Install New Modem screen, select Ericsson Voice Call Dialer, then click Next.

￿￿￿Select the COM port to which your Ericsson mobile phone is connected and click Next.

￿￿￿When Your modem has been set up successfully appears, click Finish.

￿￿￿When your desktop returns, verify that your modem is properly installed. From the Start menu, click on

￿￿

Settings, then Control Panel. Double-click the

Modems icon.

￿￿￿When the Modem Properties screen appears, click on the description of your modem and click the Diagnostics tab. Note the COM port to which your modem is assigned.

￿￿￿Click OK to proceed.

Troubleshooting

￿￿You cannot set up or maintain a data/fax session. This will occur if you are inadvertently originating a voice call when attempting a data/fax call or if the data/fax profile icon does not appear on your phone’s display after you attempt to dial or answer a data/fax call. To correct the problem, do the follow- ing:

a From the Start menu on your Windows desktop, click on Settings, then Control Panel.

b Double-click the Modems icon. c Select the General tab.

d Select Ericsson TDMA Data/Fax Modem from the pull-down list.

e Click Properties.

f Click General. Make sure that the maximum speed is set to 19200.

g Select the Connection tab. h Click Advanced.

i In the Extra settings box, type the following: +COS=4,1,2,0; +ES=1,0,1; +DS=0,0,512,6;

'DWD￿￿)D[￿￿DQG￿,QWHUQHW￿&DOOV