Getting Started

Complete the following procedures to set up your mobile phone for the first time:

Review the document conventions used in this

guide by referring to the “Document Conventions”

chapter.

Attach the belt clip to the phone by referring to the

Attaching the Belt Clip to Your Phone section in

this chapter.

Fully charge and condition your battery by refer-

ring to the Charging Your Battery section in this

chapter.

Turn your phone On by referring to the “Basic

Operations” chapter.

￿￿While making sure that the screw is going through both the plastic clip and through the metal support guide, insert the screw into the opening on the back of the phone.

￿￿Using a small Philips head

screwdriver, turn the screw clockwise until it is secure as shown in the following illus- tration. Do not over tighten the screw.

￿￿Inserting the two smaller prongs first, replace the flexible rubber plug at the top of the clip.

Attaching Your Standard or Swivel Belt Clip

Your Ericsson mobile phone is equipped with either a standard or swivel belt clip:

Standard Belt Clip

Swivel Belt Clip

￿￿Align the screw-in tab between the two guides on the back of the phone, with the thicker end on top.

￿￿Using a screwdriver, attach the tab to the phone.

￿￿Place the swivel belt clip on your belt or waistband.

Push to release phone

￿￿Remove the belt clip from the plastic bag.

￿￿Remove the flexible rubber plug from the top of the clip.

Getting Started

￿￿Slide your phone, with tab, into the swivel belt clip. To remove, press the release mechanism on the top of the clip and slide the phone up and out of the clip.

9

Page 13
Image 13
Sony Ericsson T18LX Getting Started, Attaching Your Standard or Swivel Belt Clip, Standard Belt Clip Swivel Belt Clip