Sony SCH-735 manual Troubleshooting, Exit, DIS Digital Image Stabilizer

How to Use the Camera

DIS (Digital Image Stabilizer) :

This function mitigates any picture movement due to external factors such as wind.

Notes

•The chance of resolution decrease is existed because DIS function uses the digital zoom.

•DIS doesn’t operate when background illumination is too low.

•DIS doesn’t operate when object pattern is monotonic as like sky or white wall.

•If Digital Image Stabilizer (DIS) is enabled, the digital zoom is not configured to less than 46 level.

COMM ADJ (Communication Adjustment) :

This function sets up the camera communication status when controlling the camera through an external control device.

❶When the SPECIAL menu screen is displayed, press the Up and Down buttons so that the arrow indicates ’COMM ADJ‘.

2Set up the mode using the 4 direction buttons.

-CAM ID : Determines the camera's identification number (between 0 and 25).

-BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.

-UART MODE : You can select NONE, EVEN or ODD for the parity bits.

-RET PKT : Determines whether to send a command back to the controller device when a communication control command is sent to the camera.

-DISP CAM ID : Display camera title on top left corner of the screen.

LANGUAGE : You can select the menu language according to your requirements.

RESET : Resets the camera settings to the factory defaults.

RETURN : Select this to save the SPECIAL menu settings and return to the SPECIAL menu.

EXIT

Press the SET button in the EXIT menu to save the current settings and exit the SET menu.

Troubleshooting

If you have trouble operating your camera, refer to the following table. If the guidelines do not enable you to solve the problem, contact an authorized technician.

Nothing appears on the screen.

•Check that the power cord and line connection between the camera and monitor are fixed properly.

•Check that you have properly connected VIDEO cable to the camera VIDEO output jack.

The image on the screen is dim.

•Is lens stained with dirt? Clean your lens with soft, clean cloth.

•Set the monitor to proper condition.

•If the camera is exposed to too strong light, change the camera position.

The image on the screen is dark.

•Adjust the contrast feature of the monitor or DVR.

•If you have an intermediate device, set the 75Ω/ Hi-z properly.

The camera is not working properly, and the surface of the camera is hot.

•Check that you have properly connected the camera to an appropriate power source.

The DAY/NIGHT menu does not work.

•Check that AGC of EXPOSURE SETUP menu is ’OFF‘.

The SENS-UP function does not work.

•Check that AGC of EXPOSURE SETUP menu is ’OFF‘.

•Check that SHUTTER of EXPOSURE SETUP menu is ’A.FLK‘ or ’MANUAL‘.

The Motion Detection function does not work.

•Check that MOTION DEF of SPECIAL SETUP menu is ’OFF‘.

Color is not correct.

•Check the setting of WHITE BAL SETUP menu .

The screen flickers continually.

•Check that direction of camera turns toward the Sun.

RS-485 communication fails.

•Check the polarity between RS-485 Control Port and RS-485 cable.

485 Control Board Connection Port	RS-485 Control Port
(+) CONNECTION TERMINAL (TRX+)	485+
( - ) CONNECTION TERMINAL (TRX-)	485-

•Check the RS-485 Communication establishment initial value

*RS-485 Communication establishment initial value

Item	Camera ID	BAUD RATE	UART MODE	RET PKT
Initial value	1	9600	8-NONE-1	ENABLE

•We recommend that you make ground connect between camera and controller in order to maintain safety communication control.

COLOR CCD CAMERA 38 User Guide COLOR CCD CAMERA 39 User Guide