COLOR CCD CAMERA User Guide
16
COLOR CCD CAMERA User Guide
17
•Usethelensconnectorshowninthe followingfigure.Ifthedimensionsofthe
connector are not correct, it may damage the camera, or the lens may not be
installed firmly.
•Ifthelensistooheavy,thecamerabecomes unbalancedandtheremaybe
problems.Usealensthatweighslessthan450g.
•WhenadjustingtheAutomaticLevelControl(ALC)ofanautoirislens,useAvmode
ifavailable.IfyouusethePkmode,the picturebrightnessmaychange
continuously.
Notes
Installation Procedures
Before installing a lens, identify whether the lens to be installed is a C-Mount or CS-Mount.
This camera is set for a CS-Mount Lens by default. To install a C-Mount Lens, a
simple modification is required.
• When Using a CS Mount Lens
Remove the protective glass cover at the front of this product and turn the
CS-Mount Lens clockwise to install it. And set focus of camera using Back Focus
Control Lever of camera side after combining CS-Mount lens.
When Using C/CS Mount Lens
C-MountLens:10mmorless
CS-MountLens:5mmorless
3. Remove the cover of the auto iris lens connector plug and solder the lens cable to
the connector pin of the plug.
4. Fit the cover of the auto iris lens connector
plug, remove the protective glass cover
from the front of the camera, and fasten
the auto iris lens by turning it clockwise.
• For a Video Drive Lens
Pin 1: Red (Power)
Pin 2: NC
Pin 3: White (Video Signal)
Pin 4: Black (Ground)
• For a DC Drive Lens
Pin 1: Damping -
Pin 2: Damping +
Pin 3: Drive +
Pin 4: Drive -
5. Set focus of camera using Back Focus Control
Lever of camera side after combining Auto
Iris lens.
Back Focus Control Lever
No. 3 Pin
No. 1 Pin
connector
Lens cable
No. 4 Pin
No. 2 Pin