Sony SDP-E300 Unpacking, Hookup Overview, Inserting batteries into the remote

Getting Started

Unpacking

Check that you received the following items with your processor:

•Remote controller (remote) (1)

•Size AA (R6) batteries (2)

Inserting batteries into the remote

Insert two size AA (R6) batteries with the + and – on the battery compartment. When using the remote, point it at the remote sensor g on the processor.

When to replace batteries

Under normal use, the batteries should last for about 6 months. When the remote no longer operates the processor, replace both batteries with new ones.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with an old one.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you don’t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Hookup Overview

The processor allows you to connect and control the following audio/video components. Follow the hookup procedures for the components that you want to connect to the processor on the pages specified. To learn the locations and names of each jack, see “Rear Panel Descriptions” on page 17.

			TV/VCR Hookups (5)
Speaker System				TV
	Hookups (6)
		Amplifier		VCR
					Centre
		for front
		speakers		LD player	speaker

Rear	Control Amplifier,	Active	Rear
speaker	CD player, etc...	woofer	speaker
(L)	Audio Component		(R)
	Hookups (5)

Before you get started

•Turn off the power to all components before making any connections.

•Do not connect the mains lead until all of the connections are completed.

•Be sure to make connections firmly to avoid hum and noise.

•When connecting an audio/video cable, be sure to match the colour-coded pins to the appropriate jacks on the components: Yellow (video) to Yellow; White (left, audio) to White; and Red (right, audio) to Red.

4GB