2 Press </,to move the pointer (F) to the point where you want to start playback.
The VCR starts searching and the cursor (x) moves toward the pointer. When the VCR locates the marked point, playback starts.
|
|
|
|
|
0 | 1 2 0 |
To cancel searching
Press H PLAY or x STOP.
To turn off the bar indication
Press DISPLAY again.
Notes
•The figure on the bar indication represents the total time length of the inserted tape as shown below.
The total time length may not be displayed correctly for:
–Tapes other than
–Tapes recorded in more than one tape speed mode.
Tape type | Total time length | ||
|
|
| |
| SP | LP | EP |
|
|
|
|
60 | 120 | 180 | |
|
|
|
|
from | 120 | 240 | 360 |
|
|
|
|
160 | 320 | 480 | |
|
|
|
|
•If you move the pointer (F) on the bar indication while searching, the VCR searches for the new reset point.
•With the bar indication on, the M FF/ , and m REW/ < buttons on the remote
commander work only for moving the pointer (F), while the M FF and m REW buttons on the VCR are used for normal tape operation. Note, however, if you press these buttons on the VCR, searching is canceled.
66Searching for a selected point on the tape