|
|
| Additional Information |
|
|
|
|
|
|
|
|
| SmartFile |
|
|
|
|
|
|
S14 | Recording stops | J | If the tape contains a programme protected by the SmartFile |
| halfway. |
| function, recording automatically stops before the protected |
|
|
| programme. Use another tape which has enough recording |
|
|
| space. |
|
|
|
|
| Timer recording |
|
|
|
|
| |
S15 The timer does not |
| Check that the clock is set. | |
| operate properly. |
| The clock stops if the VCR is disconnected from the mains for |
|
|
| more than an hour. Reset the clock and the timer. |
|
|
| Check that the safety tab has not been removed. |
|
|
| If the timer recording overlaps a programme protected by the |
|
|
| SmartFile function, the recording stops halfway (see page 98). |
|
|
| The recording start point overlaps the protected programme. |
|
|
| Make sure the tape is not at its end. |
|
|
| Make sure a tape has been inserted. |
|
|
| Make sure the current time has not already passed your timer |
|
|
| settings . |
|
|
| If you are recording a programme from a satellite tuner, make |
|
|
| sure the satellite tuner is turned on. |
|
|
|
|
S16 | The VPS/PDC |
| Check that the clock and the date are set correctly. |
| function does not |
| Check that the VPS/PDC time you set is the correct one (there |
| operate properly. |
| might be a mistake in the TV guide programme). If the |
|
|
| Broadcast you wanted to record did not send the good VPS/ |
|
|
| PDC information, the VCR will not start recording. |
If the reception is poor, the VPS/PDC signal might be altered and the VCR might not start recording.
Canal Plus
S17 You cannot set channels as
Be sure that DECODER/LINE4 is set to DECODER in OTHER OPTIONS menu (see page 73).
S18 | You cannot watch | Be sure that DECODER/LINE4 is set to DECODER in |
| Canal Plus when the | OTHER OPTIONS menu (see page 73). |
| VCR is in standby | Make sure the Canal Plus |
| mode. |
|
|
|
|
S19 | Make sure the Canal Plus | |
| is always recorded | Be sure that DECODER/LINE4 is set to DECODER in OTHER |
| scrambled. | OPTIONS menu (see page 73). |
|
| Be sure that this channel is set as |
|
| menu (see page 40). |
|
|
|
| Line selection |
|
|
|
|
S20 | You cannot select | Be sure that DECODER/LINE4 is set to LINE4 in OTHER |
| LINE4. | OPTIONS menu (see page 73). |
|
|
|
continued
Troubleshooting 105