Automatically adjust clock for daylight saving time changes

When you select it, the clock is automatically adjusted according to the daylight saving time of the selected time zone.

Note

If the time zone selected in Time zone is different from that set on the computer, the time is adjusted using the time zone difference and set on the camera.

OK/Cancel

See “Buttons common to every menu” on page 26.

Initialize TabReboot

Reboots the camera.

Click Reboot, and the message “The Camera will be rebooted. Are you sure?” appears. Click OK to reboot the camera. It takes about two minutes to start again.

Factory default

Resets the camera to the factory settings.

Click Factory default, and the message “Setup data will be initialized. Are you sure?” appears. When you click OK, the network indicator on the camera starts to blink. After adjustments of the default settings have finished, the camera reboots automatically. Do not turn off the camera until the camera reboots.

Tip

The camera can also be reset to the factory settings by turning on the power of this unit while pressing the reset switch on the camera. For details, see the supplied Installation Manual.

Backup setting data

Saves the setting data of the camera in a file.

Click Save, and follow the instructions on the browser to specify the folder and save the setting data of the camera. The file name preset at the factory is “snc- cs50.cfg.”

Restore setting

Loads the stored setting data of the camera.

Click Browse and select the file in which the setting data is stored. Then, click OK, and the camera is adjusted according to the loaded data and restarted.

Note

With Restore setting, some items in the Network menu (page 36) cannot be restored.

Format ATA memory card

Click Format to format the ATA memory card (not supplied) inserted into the PC card slot of the camera. The files and folders stored in the ATA memory card are deleted while formatting.

Notes

•Before formatting, disable the image memory function and the FTP server function to protect the ATA memory card against writing.

•Do not activate the Format ATA memory card function when no card is inserted into the PC card slot.

Delete custom homepage

By pressing Delete, you can delete the homepage recorded in the flash memory of the camera with Custom Homepage Installer (page 71).

Delete voice alert file

Click Delete to delete the audio file stored in the camera using SNC audio upload tool (page 66).

Note

Before deleting the audio file, set Voice alert to Off in the Voice alert menu (page 52).

Camera the Administrating

Configuring the System — System Menu

29