Attaching a CS-mount Lens
You can use a CS mount lens other than the supplied lens with this camera.
Suitable lens
The lens must be a
4 mm (3/16 in.) or less
About theYou can use a
To connect the auto iris lens, first replace the plug on the lens cable with a plug that fits the LENS connector (not supplied).
1 Detach the old plug from the lens cable.
2 Solder the wires of the lens cable to the pins of the plug.
For cable pin assignment, refer to the instruction manual of the lens.
2 1
3 8
7
6
54
1 | Cover |
|
|
2 | Lens cable |
|
|
3 | Rib (If the cable is thick, cut this off.) |
|
|
4 | Plug (not supplied) |
|
|
5 | Pin 4: Drive – (Ground) |
|
|
6 | Pin 2: Control + |
|
|
7 | Pin 1: Control – |
|
|
8 | Pin 3: Drive + |
|
|
2
1
1 Disconnect the lens cable from the auto iris lens connector.
2 Turn the lens counterclockwise to detach it from the camera.
Attaching the Lens2
13
1Align the lens with the lens mount of the camera, and turn it clockwise until it is secured.
2Insert the plug of the lens cable into the auto iris lens connector.
When fitting a
3If the focus cannot be adjusted correctly at ∞ (infinite), adjust the focal length by turning the ADJUST screw with a
Others
Attaching a