To specify the IP address manually:
Select Use the following IP address, and type the IP address, Subnet mask and Default gateway in the relevant boxes.
Preparation | 8 Set the DNS server address. |
| |
| To obtain the DNS server addresses |
| automatically: |
| Select Obtain DNS server address automatically. |
To specify the DNS server addresses manually: Select Use the following DNS server address, and type the Primary DNS server address and Secondary DNS server address in the relevant boxes.
Note
The Third DNS server address and Fourth DNS server address are invalid for this camera.
9 Set the HTTP port No.
Normally select 80 for the HTTP port No. To use another port number, select the text box and type a port number between 1024 and 65535.
10 Type the Administrator name and Administrator password.
The default settings of both items are “admin.”
Note
You cannot change the Administrator name and Administrator password in this step. To change these items, See “Setting the User — User setting Menu” on page 44.
11 Confirm that all items are correctly set, then click OK.
If “Setting OK” is displayed, the IP address is correctly assigned.
12 To access the camera directly,
Tip
The factory setting of the camera network is as follows.
IP address: 192.168.0.100
Subnet mask: 255.0.0.0
Wireless LAN setting Type: Adhoc SSID:
WEP: Nothing
The welcome page of the network camera SNC- RZ25N or
Note
If the IP address is not set correctly, the welcome page does not appear after step 12. In this case, try to set the IP address again.
10 Assigning the IP Address to the Camera