Sports Pack
Operating Instructions
Mode d’emploi
Manual de instrucciones
Gebruiksaanwijzing
SPK-PC2
Sony Corporation ©1999 Printed in Japan
A
mounting shoe | model |
sabot de montage | modèle |
|
|
A | |
B |
B
Mounting shoe A | Tripod screw plate |
Sabot de montage A | Plaquette à vis du trépied |
Mounting shoe B | Tripod screw plate |
Sabot de montage B | Plaquette à vis du trépied |
C
4
English
D
1 |
| POWER | O |
|
| L CK | |
| VTR |
|
|
| OFF |
|
|
| CAMERA | MEMORY |
|
2 |
|
| Use metal parts of |
|
|
| shoulder belt. |
3 | 4 |
| ER | |
|
|
| Y |
|
|
| A |
| |
| P | L |
|
|
|
|
|
| |
| F |
|
|
|
| F |
|
|
|
| O |
|
|
|
| C |
| R | |
| A | M | ||
|
|
| E A |
5
7
1
2
8
The model and serial numbers are located on the bottom. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product.
Model No.
Check for the water leakage before installing the camcorder.
Close the sports pack without installing the camcorder, and keep the sports pack submerged
DInstalling the Camcorder | HWhen Shooting with the LCD | ||
1 | Set the POWER switch of the |
| Screen |
|
| ||
| camcorder to OFF. | 1 | Open the mirror hood. |
2 | Attach the camera mounting shoe. | 2 | Open the wings and insert the |
| Use the metal parts of shoulder strap as |
| projections into each hole. |
| shown in the illustration. |
|
|
This mark indicates that this products is a genuine accessory for Sony video products. When purchasing Sony video products, Sony recommends that you purchase accessories with this “GENUINE VIDEO ACCESSORIES” mark.
Usable at the depth as low as 2 meters (6.5 feet) under water.For using your video camera recorder with this pack, refer to the operating instructions of the recorder.
The
under water at a depth of about 15 cm (6 inches) for about 3 minutes and then check for water leakage.
After RecordingAfter recording in a location subject to sea breezes, wash the sports pack with fresh water with the buckles fastened thoroughly, then wipe with a soft dry cloth. If water remains on the sports pack, the metal parts may rust.
Clean the inside of the pack with a soft dry cloth. Do not wash the inside of the pack. Do not use any type of solvent such as alcohol, benzine or shinner for cleaning, as this might damage the finish.
Preventing the surface of the glass from fogging upCoat the surface of the glass with the supplied
Use the small ring with 30 mm in filter diameter.
ForUse the large ring with 37 mm in filter diameter.
4Check the POWER switch of the sports pack is set to OFF.5Release the buckle.1Slide the unlock button in the direction of the arrow, and release the buckle.
2Open the side body.
6Remove the sand or dust.Check there are no dust, sand or cracks on the waterproof gasket or the surface where it touches, and grease them slightly.
7Connect the remote control plug toLANC (remote) jack sliding theClose the lower wing first.
NoteDo not hold the mirror hood directly for shooting.
IRecording a Still Picture– Photo RecordingYou can record a still picture like a photograph.
1Turn the POWER switch to CAMERA.2Press PHOTO button.The still picture is recorded.
Notes• You cannot check the still pictures by pressing |
PHOTO button of the sports pack lightly. |
• When using |
record the still pictures with the sports pack. |
• When using |
pack, memory photo recording does not work. |
•Before you start recording, make sure that the camcorder is working correctly and there is no water leakage.
•Sony does not accept liability for damage to the camcorder, battery, etc., when using the sports pack or for the cost of recording if water leakage occurs as a result of incorrect use.
Precaution
•Do not subject the front glass to strong shock, as it may crack.
•Avoid opening the sports pack in the sea or at the beach. Preparation such as installing and changing a cassette tape should be done in a place with low humidity and no salty air.
•Do not throw the sports pack into the water.
•Avoid using the sports pack under the following situations:
–in a very hot or humid place.
–in water hotter than 40˚C (104˚F).
–at temperatures lower than 0˚C.
In these situations moisture condensation or water leakage may occur and damage the equipment.
•Use the sports pack for no longer than one hour at a time in temperatures above 35˚C (95˚F).
•Do not leave the sports pack under direct sunlight for a long period of time. If you cannot avoid leaving the sports pack under direct sunlight, be sure to cover the pack with a towel or other protection.
Before You Begin
To make sure that you do not miss good shooting opportunities, go over the following checklist before installing your camcorder into the sports pack.
Apply 1 or 2 drops of cleaner liquid to the front glass and the glass of the eye cup and wipe evenly to spread the liquid out by using swabs, a soft cloth or tissue paper.
When storing the sports pack•Close the pack without fastening the buckles to prevent wear of the waterproof gasket.
•Prevent dust from collecting on the waterproof gasket.
•Avoid storing the sports pack in a cold, very hot or humid place, or together with naphthalene or camphor, as these conditions might damage the unit.
Specifications
MaterialPlastic (PC, ABS), glassWaterproofWaterproof gasket, buckleA(1)/B(1)
Tripod screw plate (1,Design and specifications subject to change without notice.
camera mounting shoe a short way into the sports pack (1), and the microphone plug to MIC (plug in power) jack (2).
When using
Check the lens and the LCD screen is clean before installing the camcorder.
Push the camera mounting shoe until it clicks.
9Close the side body.Secure the side body, and fasten the buckle until it clicks.
Note
When closing the side body, be careful not to pinch the cable. Otherwise, these parts may be damaged or water may leak in.
When using
If the connecting cord is not placed correctly when closing the side body, water leakage may occur. Place the cord correctly. (see illustration
E)
FPreparing the Sports Pack1Adjust the grip strap.Holding the sports pack so that the tips of your finger can easily touch the POWER switch, START/STOP button and ZOOM button, pull the strap to adjust its length.
2Attach the shoulder strap.The Sony mark should be on the outside.
• When using |
sports pack, you cannot use the NightShot |
function. |
You can play back pictures on the LCD screen, using the Remote Commander (supplied with your camcorder).
1Set the mirror hood.See “H When Shooting with the LCD Screen”.
2Turn the POWER switch to PLAYER.3Press N PLAY on the remote.Use the remote commander for all other functions including STOP, REW and FF.
Note
The picture on the mirror looks turned sideways.
KRemoving the CamcorderBefore opening the sports pack, wipe moisture off the sports pack and yourself. Do not allow water on the camcorder.
1Set the POWER switch to OFF.2Release the buckle and open the side body, with mirror hood side up.3Take out the camcorder and disconnect the plugs.1 Unlock the camera mounting shoe by
picking up the knob.
2Take out the camcorder.
3Disconnect the remote control plug and the MIC plug.
After removing the camcorder, put the plugs in the plug holder inside of the sports pack.
4Detach the camera mounting shoe and the reflex prevention ring.Using the Sports Pack | Note |
Notes
•When using
•When recording with this pack, we recommend you to use the battery pack of larger capacity, such as
Battery pack | Fully charged. |
Cassette tape | • The tape length will cover |
| the planned recording time. |
| • The tape is wound to the |
| point where you want to |
| start recording. |
| • The safety tab on the |
| cassette is in the correct |
| position. (The red portion is |
| not visible.) |
Waterproof | • No scratches or cracks. No |
gasket | dust, sand or hair around |
| the gasket. |
| • Correctly set in the groove. |
| (See “Note on the |
| Waterproof gasket” for |
| details.) |
|
|
Maintenance and
Precautions
Water LeakageIf water happens to leak in, stop exposing the sports pack to water immediately.
If the camcorder gets wet, take it to the nearest Sony service facility immediately.
Note on the Waterproof Gasket•Check that there are no scratches or cracks on the waterproof gasket as they may allow water to leak in. If there are scratches or cracks, replace the damaged waterproof gasket with a new one.
Do not remove the waterproof gasket with a metal tool or a tool with a sharp point.
•Put the waterproof gasket in the grooves
evenly, with the tapering side up. Never twist it. (See illustration L)
•Remove foreign materials such as dust, sand or hair from the waterproof gasket, the groove and from any surface the gasket touches.
If the body is closed with such materials present, these areas may be damaged and water may leak in.
•After checking that there are no cracks or dust on the waterproof gasket, coat it slightly with the supplied grease using your finger. This will prevent wearing.
While applying the grease, recheck for cracks or dust.
Never use cloth or paper for greasing as the fibers may cling.
Do not use any type of grease other than that supplied, as it may damage the waterproof gasket.
•The useful life of the waterproof gasket depends upon the maintenance and the frequency of use, but we recommend changing it once a year. To replace the waterproof gasket, please consult the nearest Sony dealer. Be sure to check the water leakage after replacing the waterproof gasket.
Preparing
For details, please refer to the operating instructions supplied with your camcorder.
ASelecting the CameraMounting ShoeDepending on the location of the screw hole for attaching the camera mounting shoe of your camcorder, you have a choice of two types of camera mounting shoe.
Check list A to identify the appropriate mounting shoe.
BPreparing the CameraMounting Shoe
Align the tripod screw plate to the notch of the mounting shoe A or B.
The tripod screw plate is
For details, please refer to the operating instructions supplied with your camcorder.
1Remove the shoulder strap, lens cap, filter or conversion lens from the camcorder.
2Install the battery pack.Be sure to use a fully charged battery pack.
3Insert the cassette tape.4When shooting with the LCD screen, turn the LCD panel over and move back to the camcorder with the LCD screen facing out.
5Set all the adustments of the camcorder to automatic mode.6Set the FOCUS switch to AUTO.7Set the finder power save function to OFF in the menu.8Set the START/STOP MODE switch to.
9When using10When shooting with the viewfinder using
Note
You cannot change the battery pack after attaching the mounting shoe
|
| • Be sure to disconnect the plugs before taking |
GRecording | out the camcorder. Otherwise, the plugs may | |
be damaged. | ||
1 | Turn the POWER switch to CAMERA. | • After using the sports pack, read Maintenance |
and Precautions for storing. | ||
2 | Press START/STOP button to start |
|
| recording. |
|
Press START/STOP. Press again to resume recording.
To finish recordingPress START/STOP button then turn the
POWER switch to OFF.
Zooming•Keep the W side pressed for
•Keep the T side pressed for telephoto. Press it gently for a relatively slow zoom.
Notes on recording•If you leave the camcorder for 5 minutes or more with a cassette inserted in Standby mode, the camcorder goes off automatically. This prevents battery and tape wear. To resume Standby mode, turn the POWER switch to OFF and then turn it to CAMERA again.
•During recording when the LCD screen is facing out, the counter does not appear.
•The POWER switch of the sports pack has priority over the POWER switch of the camcorder.
•If a drop of water sticks to the front glass, press the zoom button to adjust the focus.
Trouble Check
Symptom | Cause | Corrective Actions |
The sound is not | The microphone plug is not | Connect it to MIC (plug in power) |
recorded. | connected. | jack on the camcorder. |
|
|
|
There are drops of | • The buckles are not fastened. | • Fasten the buckles until they |
water inside of the |
| click. |
sports pack. | • The waterproof gasket is not set | • Put the gasket in the groove |
| correctly . | evenly. |
| • There are scratches or cracks on | • Replace the gasket with a new |
| the waterproof gasket. | one. |
The recording and | • The battery pack is run out. | • Charge the battery pack fully. |
playing back function | • The tape has run out. | • Rewind the tape or use a new |
does not work. |
| one. |
| • The safety tab on the cassette is | • Slide the safety tab or install a |
| set to unrecordable position. | new cassette tape. |
|
|
|