Listening to FM/AM radio

You can listen to FM and AM broadcasts through the built-in tuner. Before operation, make sure you have connected the FM and AM antennas to the receiver (see page 13).

Tip

The tuning scale differs depending on the area code as shown in the following table. For details on area codes, see page 2.

Area code

FM

AM

CEL, CEK, SP, AU, TW,

50 kHz

9 kHz

KR

 

 

 

 

 

 

 

 

Automatic tuning1 Rotate INPUT SELECTOR to select FM or AM.2 Press TUNING + or TUNING –.

Press TUNING + to scan from low to high; press TUNING – to scan from high to low. The receiver stops scanning whenever a station is received.

In case of poor FM stereo reception

If the FM stereo reception is poor and “STEREO” flashes in the display, select monaural audio so that the sound will be less distorted.

1Press MAIN MENU to select “TUNER”.

2Rotate MENU to select “FM AUTO”.

3Rotate –/+ to select “MONO”.

The FM reception switches to monaural.

Direct tuning

Enter a frequency of the station directly by using the numeric buttons on the remote.

For details on the supplied remote, refer to the operating instructions supplied with the remote.

1 Press TUNER on the remote repeatedly to select FM or AM.

You can also use INPUT SELECTOR on the receiver.

2 Press ALT, then press D.TUNING on the remote.3 Press the numeric buttons on the remote to enter the frequency.

Example 1: FM 102.50 MHz Press 1 b 0 b 2 b 5 b 0 Example 2: AM 1,350 kHz Press 1 b 3 b 5 b 0

If you’ve tuned in an AM station, adjust the direction of the AM loop antenna for optimum reception.

If you cannot tune in a station and the entered numbers flash

Make sure you’ve entered the right frequency. If not, repeat step 3. If the entered numbers still flash, the frequency is not used in your area.

22GB