5Press MENU +/– repeatedly until the center mode you want appears on the display. Select the center mode as follows:

If you have

Select

So that

 

 

 

Front and

NORMAL

The bass sound of the

surround

 

centre channel is

speakers, and a

 

output from the front

small center

 

speakers (because a

speaker

 

small speaker cannot

 

 

produce enough

 

 

bass).

 

 

 

Front and center

3 STEREO

The sound of the

speakers, no

(3 Channel Logic)

surround channel is

surround

 

output from the front

speaker

 

speakers.

 

 

 

Front and

PHANTOM

The sound of the

surround

 

centre channel is

speakers, no

 

output from the front

center speaker

 

speakers.

 

 

 

Front and

WIDE

The centre channel

surround

 

fully reproduces the

speakers, and a

 

entire audio

large center

 

spectrum.

speaker

 

 

 

 

 

Adjusting the speaker volume

The test tone feature lets you set the volume of your speakers to the same level. (If all of your speakers have equal performance, you don’t have to adjust the speaker volume.)

Using the controls on the remote lets you test the speaker connection and adjust the volume level from your listening position.

1Press SOUND FIELD ON/OFF to turn on the sound field.

Press SOUND FIELD MODE +/– repeatedly to select “DOLBY PL”.

2Press TEST TONE on the remote.

You will hear the test tone from each speaker sequentially.

3Adjust the volume level so that the volume of test tone from each speaker sounds the same when you are in your main listening position.

•Press MENU < or > to select “CTR xxdB” or “SURR xxdB”.

•Press MENU +/– to adjust the level.

4Press TEST TONE on the remote to turn off the test tone.

Using Surround Sound

You can adjust all speakers at one time

Adjust MASTER VOL on the remote or MASTER VOLUME on the receiver.

You can also adjust the volume level with the controls on the receiver

After pressing TEST TONE on the remote:

•Press MENU < or > repeatedly to select “CTR xxdB”. Press MENU +/– to adjust the centre speaker level.

•Press MENU < or > repeatedly to select “SURR xxdB”.

Press MENU +/– to adjust the surround speaker

level.

You can select a volume level of -15 dB to +10 dB in 1-dB steps.

You can adjust the volume level of the sub woofer

•Press LEVEL or MAIN MENU on the remote repeatedly until the LEVEL indicator lights up.

•Press MENU < or > repeatedly to select “SW xxdB”.

•Press MENU +/– to adjust the level.

You can select a volume level of -15 dB to +10 dB in 1-dB steps.

You can increase the output level of the surround speakers

The adjustment range of the surround speakers is preset from –15 to +10, but you can shift the range up 5 levels (–10 to +15).

•Press SET UP.

•Press MENU < or > repeatedly until “SURR SET UP” appears on the display.

•Press MENU +/– repeatedly until “NORMAL” appears on the display.

The values for the surround level remain fixed at –15 to +10 in the display, but you will be able to hear the difference in the actual output level.

To reset the surround level adjustment range, repeat this procedure to display “GAIN LOW”.

You can reset all sound field settings to initial setting

•Turn off the receiver.

•Hold down SOUND FIELD ON/OFF and then press ?/1 (power). "SF CLR" appears on the display.

All sound field settings will be cleared and set to sound field off.

(continued)

17GB