The FM reception is poor.
Use a
| Receiver |
Outdoor FM antenna | ANTENNA |
| AM |
Ground wire
FM(not supplied)
75Ω COAXIAL
To ground
Radio stations cannot be tuned in.
•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.
•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.
•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 30).
•Press DISPLAY so that the frequency appears in the display.
There is no picture or an unclear picture appears on the TV screen or monitor.
•Select the appropriate function on the receiver.
•Set your TV to the appropriate input mode.
•Move your TV away from the audio components.
The remote does not function.
•Point the remote at the remote sensor g on the receiver.
•Check that you select AV2 as the command mode of the receiver (page 33).
•Remove any obstacles in the path between the remote and the receiver.
•Replace both batteries in the remote with new ones, if they are weak.
•Make sure you select the correct function on the remote.
•If the remote is set to operate the TV only, use the remote to select a source or component other than TV before operating the receiver or other component.
Clearing the receiver’s memory
To clear | See |
All memorized settings | page 15 |
|
|
Customized sound fields | page 27 |
|
|