68GB
D:\NORM'S JOB\SONY HA\SO0086\STR-DN610_PMRF 2\GB\GB08ADV_STR-DN610-U2.fm masterpage: Left
STR-DN610
4-167-824-13(1)
•OFF
The receiver does not output HDMI signals
when in the standby mode. Turn on the
receiver to enjoy the connected component’s
source on the TV. This setting saves power in
the standby mode compared with the “ON”
setting.
Notes
• This parameter is not available when
“CTRL.HDMI” is set to “CTRL OFF”.
• When “AUTO” is selected, it may take a little more
time for the image and sound to be output to the TV
than when “ON” is selected.
• When the receiver is in standby mode, “HDMI”
indicator will lights up if “PASS.THRU” is set to
“AUTO” or “ON”. However, when “PASS.THRU”
is set to “AUTO”, this indicator will lights off if no
signals are detected.

xAUDIO.OUT

Lets you set the HDMI audio output from the
playback component connected to the receiver
via an HDMI connection.
•AMP
The HDMI audio signals from the playback
component are only output to the speakers
connected to the receiver. Multi channel
sound can be played back as it is.
Note
Audio signals are not output from the TV’s
speakers when “AUDIO.OUT” is set to “AMP”.
• TV+AMP
The sound is output from TV’s speaker and
the speakers connected to the receiver.
Notes
• The sound quality of the playback component
depends on the TV’s sound quality, such as the
number of channels, and the sampling frequency,
etc. When the TV has stereo speakers, the sound
output from the receiver is also stereo as that of
the TV, even if you play back multi channel
software.
• When you connect the receiver to an image
display component (projector, etc.), sound may
not be output from the receiver. In this case,
select “AMP”.

xSW LEVEL

Lets you set the level of the subwoofer to 0 dB
or +10 dB when multi channel Linear PCM
signals are input via an HDMI connection. You
can set the level for each HDMI input
independently.
•SW AUTO
Automatically sets the level to 0 dB or
+10 dB depending on the frequency.
• SW +10 dB
• SW 0 dB
Note
This parameter is only available when HDMI input
signals are detected.

xSW L.P.F.

Lets you set the low pass filter of the
subwoofer when multi channel Linear PCM
signals are input via an HDMI connection. Set
the “SW L.P.F.” if your connected subwoofer’s
crossover frequency do not have low pass
filter.
• L.P.F. ON
The low pass filter of the subwoofer’s cut off
frequency is set to 120 Hz.
• L.P.F. OFF
The low pass filter of the subwoofer is
turned off.
Note
This parameter is only available when HDMI input
signals are detected.

xARC

Let you enjoy the TV sound from the speakers
connected to the receiver via an HDMI cable.
For details, see “Enjoying the TV sound via an
HDMI cable” (page 54).
• ARC ON
Audio signal is input to the HDMI TV OUT
jack.
• ARC OFF
Audio signal is input to the TV OPTICAL
IN jack or TV AUDIO IN jack.
Note
This parameter is not available when
“CTRL.HDMI” is set to “CTRL OFF”.