The table below shows the display when measurement starts.

Measurement for

Display

Speaker existance

TONE

 

 

Speaker gain, distance,

T.S.P.

frequency response

 

 

 

Subwoofer gain and distance

WOOFER

 

 

Note

You cannot measure the speaker height of the surround speakers and the surround back speakers. Set this value using “SUR POS.” parameters in the SYSTEM menu (page 42).

Tips

•The Auto Calibration function will be canceled when you do the following during the measurement process:

–Press ?/1, input buttons or MUTING on the remote.

–Press SPEAKERS (OFF/A/B/A+B) or turn the INPUT SELECTOR on the receiver.

–Change the volume level.

–Press AUTO CAL again.

–Connect the headphones.

•The measurement may not be performed correctly or Auto Calibration cannot be performed when special speakers, such as dipole speakers are used.

Confirming/saving the measurement results

1 Confirm the measurement

Getting

 

 

result.

 

 

Started

 

When the measurement ends, a beep

 

 

 

sounds and the measurement result

 

 

appears on the display.

 

 

 

 

 

 

 

Measurement Display

Explanation

 

 

result

 

 

 

 

 

 

 

 

 

When the

SAVE

Proceed to step

 

 

measurement

 

2.

 

 

process

 

 

 

 

completes

 

 

 

 

properly

 

 

 

 

 

 

 

 

 

When the

ERROR

See “When

 

 

measurement

XXXX

error codes

 

 

process fails

 

appear” (page

 

 

 

 

32).

 

2 Press RECEIVER and then press V/v repeatedly to select the item. Then, press .

Item

Explanation

 

RETRY

Performs the Auto

 

 

Calibration again.

 

 

 

 

 

SAVE

Saves the measurement

 

 

results and exits the setting

 

 

process.

 

 

 

 

 

WARN CHK

Displays warning

 

 

concerning the

 

 

measurement results. See

 

 

“When you select “WARN

 

 

CHK”” (page 32).

 

 

 

 

 

PHASE

Displays the phase of each

 

 

speaker (in phase/out of

 

 

phase). See “When you

 

 

select “PHASE”” (page 33).

 

 

 

 

 

DISTANCE

Displays the measurement

 

 

result for speaker distance.

 

 

 

 

 

LEVEL

Displays the measurement

 

 

result for speaker level.

 

 

 

 

 

EXIT

Exits the setting process

 

 

without saving the

 

 

measurement results.

 

 

 

 

 

 

continued

 

 

 

 

 

31US