Sony STRDG810 When error codes appear, When you select “WARN CHK”

3 Save the measurement result.

Select “SAVE” in step 2.

The measurement results are saved and you can select the calibration type in the A. CAL menu.

For details on calibration type, see page 33.

Tip

The size of a speaker (LARGE/SMALL) is determined by the low frequency characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the SYSTEM menu (page 42). Save the measurement results first, then try to change the settings if you want.

When error codes appear

Try the remedies and perform the Auto Calibration again.

Error code Cause and remedies

ERROR 31 SPEAKERS (OFF/A/B/A+B) is set to off. Set it to others and perform the Auto Calibration again.

ERROR 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and perform the Auto Calibration again.

If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected.

ERROR F 33 • None of the front speakers are connected or only one front speaker is connected.

•The optimizer microphone is not connected.

ERROR SR 33 • Either the left or right surround speakers is not connected.

•Surround back speakers are connected even though surround speakers are not connected. Connect the surround speaker to the SPEAKERS SURROUND terminals.

•CODE 31

1Press RECEIVER, then press , then follow the instructions from step 1 of “Performing Auto

Calibration”.

•CODE 32, 33

1Press RECEIVER, then press , “RETRY Y” appears on the display.

2Press again.

3Follow the instructions from step 2 of “Performing Auto Calibration”.

When you select “WARN CHK”

If a warning on the measurement result is present, detailed information is displayed.

Press to return to step 2 of “Confirming/saving the measurement results”.

Warning code Explanation

WARN 40	The Auto Calibration has
	completed. However, the noise
	level is high. You may be able to
	perform the Auto Calibration
	properly if you try it again, even
	though the measurement cannot
	be performed in all environments.
	Try to perform the Auto
	Calibration in a quiet
	environment.
WARN 41	The sound input from the
	optimizer microphone is out of
	the acceptable range. It is louder
	than the loudest sound that can be
	measured. Try to perform the
	Auto Calibration when the
	environment is quiet enough to
	allow proper measurement.
WARN 42	The volume of the receiver is out
	of the acceptable range. Try to
	perform the Auto Calibration
	when the environment is quiet
	enough to allow proper
	measurement.
WARN 43	The distance and position of a sub
	woofer cannot be detected. This
	may be caused by noise. Try to
	perform the Auto Calibration in a
	quiet environment.
NO WARN	There is no warning information.

32US