Inserting batteries into the remote

Insert two R6 (size-AA) batteries in the RM-AAU055 Remote Commander. Observe the correct polarity when installing batteries.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with old ones.

•Do not mix manganese batteries and other kinds of batteries.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

•When you replace the batteries, the remote buttons may be reset to their factory settings. If this happens, reassign the buttons again (page 28).

•When the remote no longer operates the receiver, replace all the batteries with new ones.

6: Selecting the speaker

system

 

 

Getting

 

 

 

You can select the speakers you want to drive,

Started

if you have connected the speakers to

 

SPEAKERS A and B terminals.

 

 

Be sure to use the buttons on the receiver for

 

this operation.

 

 

 

SPEAKERS (OFF/A/B/A+B)

 

 

 

 

MASTER VOLUME

 

INPUT SELECTOR

 

 

 

SPEAKERS

 

 

 

(OFF/A/B/A+B)

 

 

 

FM MODE

MEMORY/

DISPLAYDIMMER MUTING

 

TUNING MODE TUNING ENTER BASSTREBLE

 

PHONES

Press SPEAKERS (OFF/A/B/A+B) repeatedly to select the speaker system you want to drive.

To select

Light up

The speakers connected to the

SP A

SPEAKERS A terminals

 

 

 

The speakers connected to the

SP B

SPEAKERS B terminals

 

 

 

The speakers connected to both the

SP A

SPEAKERS A and B terminals

SP B

(parallel connection)

 

 

 

To turn off the speaker output

Press SPEAKERS (OFF/A/B/A+B) repeatedly until the “SP A” and “SP B” indicators on the display do not light up.

Note

You cannot switch the speaker system by pressing SPEAKERS (OFF/A/B/A+B) when the headphones are connected.

17GB