Radio stations cannot be tuned in.
•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.
•The signal strength of the stations is too weak (when tuning in with auto tuning). Use direct tuning.
•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 24).
•Press DISPLAY repeatedly on the receiver so that the frequency appears on the display.
RDS does not work.*
•Make sure that you are tuned to an FM RDS station.
•Select a stronger FM station.
The RDS information that you want does not appear.*
•Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.
*Models of area code CEL, CEK only.
Remote commander
The remote does not function.
•Point the remote at the remote sensor on the receiver.
•Remove any obstacles in the path between the remote and the receiver.
•Replace all the batteries in the remote with new ones, if they are weak.
•Make sure you select the correct input on the remote.
If there is a malfunction, the display shows a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.
PROTECT
Irregular current is output to the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.
If the problem persistConsult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.
Reference sections for clearing the receiver’s memory
To clear | See |
All memorized settings | |
|
|
32GB