SECTION 1
SERVICING NOTES
MODEL IDENTIFICATION
– Specification Label –
MODEL NO. TA-P9000ES
MULTI CHANNEL PRE AMPLIFIER
SERIAL NO.
MADE IN JAPAN
US, Canadian models : AC 120V 60Hz 20W
AEP model : AC 220 - 230V 50/60Hz 20W
Notes on chip component replacement
•Never reuse a disconnected chip component.
•Notice that the minus side of a tantalum capacitor may be dam- aged by heat.
SAFETY CHECK-OUT
After correcting the original service problem, perform the follow- ing safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, screws, and all other exposed metal parts for AC leakage. Check leakage as described below.
LEAKAGE TEST
The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.5 mA (500 microampers.). Leakage current can be measured by any one of three methods.
1.A commercial leakage tester, such as the Simpson 229 or RCA
2.A
3.Measuring the voltage drop across a resistor by means of a VOM or
To Exposed Metal
Parts on Set
0.15∝F
AC
1.5 k Ωvoltmeter
(0.75 V)
Earth Ground
Fig. A. Using an AC voltmeter to check AC leakage.