Sony TC-KA6ES, TC-KA3ES Setting the voltage selector (only on models supplied with a voltage selector), Getting Started, Where do I go next, Connecting the AC power cord, ç L

Getting Started

To connect your tape deck to another tape deck

Connect both tape decks as shown below.

Tape deck		Another tape deck
LINE			LINE
IN	OUT	IN	OUT
L	L	ç L	L
R	R	R	R

Ç

Setting the voltage selector (only on models supplied with a voltage selector)

Check that the voltage selector on the rear panel of the tape deck is set to the local power line voltage. If not, set the selector to the correct position using a screwdriver before connecting the AC power cord to an AC outlet.

VOLTAGE

220V

240V

120V

Connecting the AC power cord

Connect the AC power cord to an AC outlet.

The dape deck’s Memory Backup function (page 17) keeps the various settings in memory even after you trun off the power as long as AC power cords is plugged in.

Where do I go next?

Now you’re ready to use your tape deck.

For basic operations, go to pages 4 to 6; for advanced operations, go to the sections immediately after this one.

8EN