Unpacking
Check that you received the following items:
• Audio connecting cords (2)
Hooking Up the System
This section describes how to hook up the tape deck to an amplifier or a CD player equipped with CONTROL A1 connectors. Be sure to turn off the power of each component before making the connections.
Tape deck
Ç | ç | to an AC |
|
| |
|
| outlet |
REC TAPE
OUT IN
Amplifier
to a
wall outlet
CONTROL
A1
CD player
ç: Signal flow
•Connecting the tape deck to an amplifier
Connect the amplifier to the LINE IN/OUT connectors using the supplied audio connecting cords.
When connecting an audio connecting cord, be sure to match the
Tape deck | Amplifier | |
Ç |
|
|
|
| TAPE |
IN OUT | OUT | IN |
| ||
L | L | L |
R | R | R |
ç
ç: Signal flow
•Connecting the tape deck to a CD player equipped with CONTROL A1 connectors
For information on connections through the CONTROL A1 connectors, refer to the pamphlet included with this manual.
Setting the voltage selector (only on models supplied with a voltage selector)Check that the voltage selector on the rear panel of the tape deck is set to the local power line voltage. If not, set the selector to the correct position using a screwdriver before connecting the AC power cord to an AC outlet.
VOLTAGE
220V 240V
110V 120V
Connecting the AC power cordConnect the AC power cord to an AC outlet.
Where do I go next?Now you’re ready to use your tape deck.
For basic operations, go to pages 5 to 7; for advanced operations, go to the sections starting from page 8.
4GB