VPCS1 Series Optical Disk Drive
Replacement Instructions
IMPORTANT!
PLEASE READ BEFORE YOU START
These easy instructions are intended to guide you through the replacement process.
Before you begin, place your notebook computer on a clean or covered surface to avoid damage to the computer's case.*
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
oHold parts by the edges, away from exposed circuitry when possible.
oDo not walk around excessively as this promotes static
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface of your notebook computer.*
The appearance of the electronic components shown in the illustrations may be different from the components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for damage caused by incorrect handling of the notebook computer.
Battery
Optical Disk Drive
Hard Drive Door
Prepare the Computer
CAUTION: Make sure the computer is turned off, the lid is closed, and the AC Adapter is disconnected. Failure to do so can result in damage to the computer.
Step 1. Place the computer upside down on a protected surface with the front edge facing you.
1.
2.
3.
Lift to remove
Remove the Battery Pack
Step 2.
1)Slide the left battery tab to the unlock position.
2)With your right thumb, slide the right battery tab to the left and hold.
3)Lift the battery with your left thumb using the notch at the bottom.
Hard Drive Door
Door
ODD Removal
(Steps 3-8)
Step 3. Using the enclosed magnetic screwdriver, remove the two (2) screws securing the Hard Drive Door.
Put aside the Hard Drive Door
Screws to
Drive Door later in the procedure.
P/N 989201343 | Rev. B | 1/4 |