6 Turn the projector back over.7 Connect the power cord and turn the projector to standby mode.

8 Press the following keys on the control panel in the following order for less than five seconds each: RESET, <, ,, ENTER.

Notes

•Be sure to use the LMP-C132 (for VPL- CX10) or LMP-C133 (for VPL-CS10) Projector Lamp for replacement. If you use lamps other than LMP-C132 or LMP-C133, the projector may cause a malfunction.

•Be sure to turn off the projector and unplug the power cord before replacing the lamp.

•Do not put your hands into the lamp replacement spot, or not fall any liquid or object into it to avoid electrical shock or fire.

Cleaning the Air Filter

The air filter should be cleaned every 300 hours. When it becomes difficult to remove the dust from the filter, replace the filter with a new one.

To clean the air filter, follow the steps below:

1 Turn off the power and unplug the power cord.2 Turn the projector over.
3 Remove the air filter cover.4 Remove the dust from the filter with a vacuum cleaner.5 Attach the air filter and replace the cover.

Notes

•If the air filter is excessively dirty, wash it with mild detergent solution and dry it in a shaded place. If the dust cannot be removed, replace the air filter with the supplied new one.

•Be sure to attach the air filter cover firmly; the power will not be turned on if it is not closed securely.

•The air filter has a face and a reverse side. Place the air filter so that it fits in a notch on the air filter cover.

To clean the ventilation holes

When you clean the air filter, clean the ventilation holes (intake, rear) also. Remove the dust from the outside of the ventilation holes with a vacuum cleaner.

GB 32 Maintenance