15
Making a Wired Connection with a Computer
Preparation
Start from the display shown in “When the
IP Address is not assigned automatically.”
Input of the IP Address, Subnet Mask and
Default Gateway is required for the
configuration. Before starting, contact your
network administrator.
1Press the v or V key on the remote

commander to select “Simple Setting”

then press the ENTER key.
The message “Simple Setting started.”
appears on the screen.
2Press the B key.
The following menu appears:
3Press the v or V key on the remote

commander to select “IP Address”

then press the ENTER key.
The on-screen keyboard appears.
4Enter “IP Address” with the on-screen

keyboard. Input “Subnet Mask” and

“Default Gateway” as well.

For the procedure for using the on-
screen keyboard, see “Using the On-
Screen Keyboard” on page23.
When you complete the settings, the
following menu is displayed on the
screen:
5Press the ENTER key to quit “Simple

Setting.”

The specified IP Address is displayed
under “Network Address.”
• If the en tered IP Address is not correc t, the
connection will not be made even if the IP
Address is shown under “Network Address.”
• If you entered an incorrect IP Address, you
cannot correct the setting with “Simple
Setting.” In this case, initialize the settings,
referring to “Initializing the Network
Setting” on page22, then configure the
settings again with “Configuring Using
Simple Setting” on page 15. You can also use
the menu to set the IP Address, referring to
“Configuring the Network Settings Using the
Menu” on page19.

Configuring Using Simple

Setting

Before starting
Windows Vista® Network Projector
Select:
Projector not connected to network.
Set the Network setting
with Simple Setting or the Menu.
Set:
Switch
Detail Information
Simple Setting
Simple Setting
IP address not obtained automatically.
Enter manually.
Subnet MaskIP AddressDefault Gateway
Prev.:
. . . . . . . . .
Exit:
Select: Set:
Notes
Simple Setting
Simple setting completed.
Close
Prev.: Exit: Set:
SonyProj99808B8
192.168.0.1
address" and "Projector password" at
"Connect to a Network Projector" of
Windows Vista
®
.
Search for a projector or enter the "Network
Network Name (SSID):
Projector Name:
Network Address:
Projector Password:
Select: Set:
Switch
Detail Information
Windows Vista® Network Projector