Connecting
Connecting with a Computer
This section describes how to connect the projector with a computer. For details on how to connect a VCR or component equipment, see page 20 (EN).
When the projector is connected to a computer, you can control the mouse of a computer by the Remote Commander.
The R/L CLICK keys and joy stick function as follows.
Note
Make sure that there is nothing to obstruct the infrared beam between the
Remote Commander and the remoter control detector on the projector.
Key and joy stick |
| Function | |
| IBM PC/ATa) |
| Macintosh |
| compatible, Serial |
|
|
|
|
|
|
R CLICK (front) | Right button |
| Mouse button |
|
|
|
|
L CLICK (rear) | Left button |
| Mouse button |
|
|
| |
Joy stick | Corresponds with the movements of the mouse | ||
|
|
|
|
a)IBM PC/AT is a registered trademark of International Business Machines Corporation, U.S.A.
Also refer to the instruction manual of equipment to be connected.
Notes
•This unit accepts the VGA, SVGA and XGA signals. However, we recommend you to set the output mode of your computer to the SVGA mode for the external monitor.
•If you set your computer, such as a notebook type IBM PC/AT compatible, to output the signal to both the display of your computer and the external monitor, the picture of the external monitor may not appear properly. In such cases, set the output mode of your computer to output the signal to only the external monitor.
For details, refer to the operating instructions supplied with your computer.
When making connections, be sure to:
•turn off all equipment before making any connections.
•use the proper cables for each connection.
•insert the plugs of the cables properly; plugs that are not fully inserted often generate noise. When pulling out a cable, be sure to pull it out from the plug, not the cable itself.
18 (EN)