Sony XC-EU50, XC-EU50CE 14

Mode Setting

For setting the shutter speed using the trigger pulse width

HD/VD input

◆Continuous HD input/Single VD input

Mode transition state

External input

External trigger

External trigger shutter operation

inhibition area

Normal operation*3

(50 ms)

shutter operation

Trigger*1

Trigger pulse width*3

Exposure time (Te)*2

Exposure time

External HD*1

(Te)*2

External VD*1

(Single VD)

min 10 ∝s

T: T=10 ∝s to 65 ms*4

Video out

WEN

250 H (EIA)

293 H (CCIR)

*1 This is a signal input from outside. Make sure to input both HD and VD signals in this case. Input the signal so that the VD phase aligns with the HD falling edge.

*2 Exposure time (Te)

Te = Trigger pulse width + 97 ∝sec (EIA) Te = Trigger pulse width + 120 ∝sec (CCIR) (The effective trigger pulse width for the external trigger shutter operation is between 2 ∝s and 1/4 s.)

*3 The normal operation state is chosen when the trigger pulse width is 1/3 s or more. (By entering a continuous VD in this section, an image is output.) The trigger falling edge restores the external trigger shutter operation. In this case, the area between the falling edge of a trigger pulse and the subsequent 50 ms period is an external trigger input inhibition area. There is no guarantee of operation for any trigger input selected in this period.

*4 Input the external VD within the period of 10 ∝s to 65 ms after the trigger falling edge (1 and 2 in the figure). There is no guarantee of operation when any other input is selected. If an invalid signal is input, the input is changed to a valid signal and, after several V signals, normal operation will resume.

*5 When the external trigger shutter mode changes to the normal operation mode, one WEN signal is output.

Note

Make sure that the trigger signal and the VD signal make up a pair.

An image is not output correctly when the next trigger is input before the image for the previous trigger is output.