Overview

Location of Parts and Operation

Front/Top/Bottom

Rear Panel

 

 

1

 

2

5

 

 

 

3

TRIG IN

6

 

7

TRIG GND

 

 

4

3

TRIG IN

 

2 1

1Lens mount (C-mount)

Attach any C-mount lens or other optical equipment.

Note

5CAMERA connector

Connect the IEEE1394 camera cable (supplied) to this connector.

The lens must not project more than 7 mm (9/32 inch) from the lens mount.

1Lens mount face 2 7 mm (9/32 inch) or less

2Reference holes (Top)

3 Reference holes (Bottom)

These precision screw holes are for locking the camera module. Locking the camera module into these holes secures the optical axis alignment.

4Tripod adaptor screw holes

Screw the tripod adaptor VCT-ST70I into the four screw holes when you use a tripod.

6Pilot lamp

This lamp indicates the camera module operation states:

OFF: Camera power OFF

Green: Camera power ON/Video signal output OFF

Orange: Camera power ON/Video signal output ON

7TRIG IN/Exposure OUT connector

Connect the trigger signal generator (trigger output connector) to this connector.

When trigger is OFF, or software trigger is ON, a signal that indicates the exposure time is output from the BNC connector of the camera.

XCD-SX910CR/X710CR

 

XCD-SX910UV

7

XCD-SX910/X710