Troubleshooting
If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer.
There’s no sound.
•Check that the player is connected securely.
•Make sure you operate the amplifier correctly.
•Adjust the analog output level with ANALOG OUT LEVEL
The CD does not play.
•There’s no CD inside the player.
•Place the CD with the label side up on the disc tray correctly.
•Clean the CD (see page 17).
•Moisture has condensed inside the player. Remove the disc and leave the player turned on for about an hour.
The recording level has changed.
•The recording level changes if you adjust the analog output level with ANALOG OUT LEVEL
The remote does not function
•Remove the obstacles in the path of the remote and the player.
•Point the remote at the remote sensor on the player.
•Replace all the batteries in the remote with new ones if they are weak.
Specifications |
| ||
Compact disc player |
| ||
Laser |
| Semiconductor laser (λ = | |
|
| 780 nm) |
|
|
| Emission duration: | |
|
| continuous |
|
Frequency response | 2 Hz to 20 kHz ± 0.5 dB | ||
Dynamic range | More than 93 dB | ||
Harmonic distortion | 0.0045% |
| |
Outputs |
|
|
|
|
|
|
|
| Jack | Maximum | Load |
| type | output level | impedance |
ANALOG | Phono | 2 V | Over 10 |
OUT | jacks | (at 50 | kilohms |
|
| kilohms) |
|
|
|
|
|
DIGITAL | Optical | Wave length: | |
OUT | output |
| 660 nm |
(OPTICAL) | connector |
|
|
|
|
|
|
PHONES | Stereo | 10 mW | 32 ohms |
|
| ||
only) | jack |
|
|
|
|
|
|
General |
|
|
|
Power requirements |
|
| |
Canadian models: | 120 V AC, 60 Hz | ||
European models: | 230 V AC, 50/60 Hz | ||
Power consumption | 11 W |
| |
Dimensions (approx.) | 430 x 95 x 290 mm | ||
(w/h/d) |
| incl. projecting parts | |
Mass (approx.) | |||
|
| ||
|
|
Audio cord (2 phono plugs
R6 (size AA) batteries (2)
Design and specifications are subject to change without notice.