Listening to the iPod (continued)
To insert iPod adaptor
1Open the iPod cover by pulling up the tip.
pull up
2 Insert the iPod adaptor into the iPod dock and connect your iPod.
CD
USB
iPod
iPod (bottom)
Dock connector
iPod adaptor 
(not supplied)
iPod dock 
iPod connector 
To remove iPod adaptor
Insert the tip of a screwdriver
iPod playback
1Press the
2Press the iPod button on the remote control or FUNCTION button repeatedly on the main unit to select iPod function.
3Insert iPod unit in iPod dock of main unit.
4Press the 
/
button to start playback.
Notes:
●Once the iPod is connected to the unit it will begin charging.
●The iPod unit cannot be charged while the main unit is in the
●Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple’s homepage for further information.
To disconnect iPod
Simply remove the iPod from the iPod dock. It is safe to do so even during playback.
Navigating the iPod menus
1Press the MENU button to view the menu on iPod unit. Press it again to go back to previous menu.
2Use the TUNING (
or 
) button on the remote control to select an item on the menu and then press ENTER button.
Note:
When navigating the iPod menus with remote control, do not operate any of the buttons on the iPod unit.The volume level is adjusted by pressing the VOL (+ or
iPod operation:
The operations described below depend on the generation iPod you are using.
System on operation:
When the main unit is powered on, the iPod unit will automatically power on when docked in the unit (including TIMER function/exclude USB function).
System off (stand-by operation):
When the main unit is turned to
