Using the rotary commander
By rotating the control (the SEEK/AMS control)
The rotary commander works by pressing buttons and/or rotating controls.
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
(MODE)
Each time you press (SOURCE), the source changes as follows:
TUNER nCD* nMD* nTAPE
Pressing (MODE) changes the operation in the following ways;
•Tape : playback direction
•Tuner : FM1 nFM2 nFM3 nMW n SW1 nSW2
•CD unit* : CD1 nCD2 n…
•MD unit* : MD1 nMD2 n…
*If the corresponding optional equipment is not connected, this item will not appear.
Tip
When the POWER SELECT switch is set to position B, you can turn on this unit by pressing (SOURCE) on the rotary commander.
Rotate the control and release it to: •Locate the beginnings of tracks on the
tape. Rotate and hold the control momentarily, then release it to
•Locate a specific track on a disc. Rotate and hold the control until you locate the specific point in a track, then release it to start playback.
•Tune in stations automatically. Rotate and hold the control to find a specific station.
By pushing in and rotating the control (the PRESET/DISC control)
Push in and rotate the control to: •Receive the stations memorized on the
number buttons. •Change the disc.
Other operations
Rotate the VOL control to
adjust the volume.
Press (ATT) to attenuate the sound.
OFF
Press (OFF) to turn off the unit.
12