For stations without alternative frequenciesPress either side of (SEEK) while the station name is flashing (within8 seconds).

The unit starts searching for another frequency with the same PI (Programme Identification) data (“PI SEEK” appears). If the unit cannot find the same PI, the unit returns to the previously selected frequency.

Staying with one regional programme

When the AF function is on: this unit’s factory setting restricts reception to a specific region, so you won’t be switched to another regional station with a stronger frequency.

If you leave this regional programme’s reception area and would like to take advantage of the whole AF function, select “REG-OFF” from the MENU (page 18).

Note

This function does not work in the United Kingdom and in some other areas.

Local Link function (United Kingdom only)

This function enables you to select other local stations in the area, even if they are not stored on your number buttons.

1 Press a number button ((1) to (6)) on the card remote commander that has a local station stored on it.

2 Within 5 seconds, press the number button of the local station again.3 Repeat this procedure until the desired local station is received.
Receiving traffic announcements— TA/TP

By activating the Traffic Announcement (TA) and Traffic Programme (TP), you can automatically receive FM station broadcast traffic announcements as they occur. These settings function regardless of the current FM programme/source, CD/MD; the unit switches back to the original source when the bulletin is over.

Press (TA) repeatedly until “TA-ON” appears.

The unit starts searching for traffic information stations.

“TP” indicates reception of such stations, and “TA” flashes during an actual traffic announcement. The unit will continue searching for stations available with TP if “NO TP” is indicated.

To cancel all traffic announcements, select “TA- OFF.”

To

Press

Cancel current

(TA)

announcement

 

 

 

Tip

You can also cancel a current announcement by pressing (SOURCE) or (MODE).

Presetting the volume level of traffic announcements

You can preset the volume level of the traffic announcements so you won’t miss hearing them.

1 Turn the volume control dial to adjust the desired volume level.2 Press (TA) for 2 seconds.

“TA” appears and the setting is stored.

Receiving emergency announcements

If either AF or TA is on, the unit will switch to emergency announcements, if one comes in while listening to an FM station, a tape or optional CD/MD.

13