Adding some tape…
Before you go any further you need to add some masking tape or scotch tape as shown in Figure 1 and Figure 2.
In Figure you 1 need to add some tape to hold the LCD screen in place during the camera modifications. If you do not add this the LCD will fall out and can be damaged.
In Figure 2 you need to add the tape here to mask off the flash contact points. If you do not add this tape and touch these contact points you will be shocked.
Be sure to remove this tape when closing the case back up after your modification is finished.
Remove the shutter board screw
Next remove the shutter board screw as shown and carefully lift the shutter board and plastic housing from the camera.
Figure 1
Figure 2
