Configuration Tips | Sony Ericsson LBI-38965 specs

LBI-38965

Configuration Tips

If all 16 ports of a terminal server are needed for System Manager interface, first configure 15 of them using a “dumb” terminal connected to port 1. Port 1 (configuration port) may then be re-assigned to a remote port, accessible via a telnet connection. Telnet into the terminal server on the OVERRIDE port number, and reconfigure port 1 as required. Refer to the Emulex Terminal Server user’s manual for additional information on server configuration via a telnet connection.

The up arrow on a VT100 can be used to recall commands to the terminal server, allowing the user to reissue the same command to each port on the server by only changing port_no.

NOTE

The push button switch (marked default) on the front of the Emulex P2516 terminal server will erase all configuration information in the terminal server and return it to the factory default state. Do not use this switch to reset the terminal server. Cycle power or issue the “Initialize server” command from the server configuration port to restart the terminal server.

Ericsson GE Mobile Communications Inc.

Mountain View Road ∙ Lynchburg Virginia 24502

Printed in U.S.A.

33

Image 33

Sony Ericsson LBI-38965 installation manual Configuration Tips

Contents

System and Installation Manual LBI-38965 Table of Contents Table of Contents BCU/CAL Architecture Introduction BCU Functional Description CAL Functional DescriptionCall Types Supported Physical Description and Compatibility Physical Specifications TVME147 CPU BCU/CAL Architecture CPU Backwards Compatibility Compatibility Specifications Common BCU and CAL Operational SpecificationsBCU Operational Specifications Billing Architecture BCU Operation Overview Billing Architecture RF Channel Usage Air Time Group Billing ModeConversations Grouping Calls File Name Contents Operator Functions Default DataDatabase Elements Unit Data Call Processing CDR Processing ErrorsCDR Processing Call Processing CDR Output CAL Operational Specifications System Manager InterfaceProtocol Supported CAL Operation Overview Additional Product Features Network File System Hardware Installation Installation Installation Contents Diskette Software Installation Parameter Meaning File Name Usage Parameter EXPORTS.DAT Configuration File Directory Clientip EXPORTS.DAT File Parameters CAL.DAT Configuration File SITE01 CAL.DAT File Parameters Prerequisites Initial Installation Installation Return First-Time Configuration Default System AccountsLogin Password Access Level User Information Entering bcs invokes the BCS program Prerequisite System Disk Booting User Information Invoke the BCS program Proper System Shutdown Software Upgrades CAL Terminal Server Configuration Example Configuration Tips Page Appendix a Edacs Billing CDR Format Billing by Conversation OverviewBilling for Multiple Sites Record Encoding SINGLE-SITE Calls Record LayoutMULTIPLE-SITE Calls MOBILE-TO-LAND Telephone Interconnect Calls Name Size Format Range/Values Description Table A.1 Call Detail Record Field Descriptions Call Type Definitions Table A.2 Call TypesCall Type Description Valid with Hex Decimal Rec. Type A0-FF Table A.3 Call Type Bit Field Definitions Call Type Bit Fields CDR File Topics Appendix B Physical Configuration Details Jumper Settings Figure B.1 Tvme 147SA1 Single-Board Computer Figure B.2 Tvme 712/M Transition Module Figure B.4 fv5310 Main Board Figure B.5 fv5310 Mezzanine Card Scsi Connector Pwr Cable Pinouts DB-25F Signal Name Function ConnectorTable B.1 WANServer Port Table B.2 WANServer Port Table B.4 WANServer Port Table B.3 WANServer Port DB-25M Connector Signal Name Function BCU/CAL Port Table B.5 BCU/CAL Hdlc Loopback Cable Specification Figure B.9 CAL Terminal Server to Distribution Panel Cable A14 INM AC H106 Computer Terminal Appendix C Fault Tolerance Redundant Operation Figure C.1 Edacs Billing Fault Tolerant Architecture